Wynkly - NextGen Social Network

High Speed Punching Machine Specs Read From the Shop Floor

4 min read
0
Comments
19
Views

Faster strokes or a longer feed is the trade-off most buyers run into first, because the figure that looks best on a quotation is seldom the one that decides how many good parts come off the line, and I have seen people choose a High Speed Punching Machine on stroke rate alone and then discover that their strip needed a feed length the machine handled awkwardly. It helps to start from the part drawing, the thickness of the stock and the shape of the strip coil, and only then to look at what the press is rated to do.

Material and thickness come before everything else, since a press that stamps thin copper or aluminium strip with a light, brisk action is a different animal from one that has to pierce stiffer steel, and the force rating is meant to cover your thickest, hardest stock with room left over rather than sit right at its edge. Ask what material the quoted rate was measured on, and whether that rate was taken with a simple blank or with a die that has many small holes, because a die with fine features slows the whole cycle and wears faster.

Die space is the next thing I measure myself with a tape, not the brochure, and that means the shut height, the bolster area and the room beside the die for the feed rollers and the scrap chute. A die that fits on paper but leaves no gap for a hand and a spanner will be a nuisance at every changeover, and the changeover is where small shops lose a surprising part of the day, so ask how long a die swap takes with the tools they would actually have on hand.

TARUN mainly engages in research and development, manufacturing and sales of metal processing machinery, industrial automation equipment, hardware tools, power tools, abrasives and insulating materials, and a spread like that is a reminder to ask how the press talks to whatever feeders, uncoilers and counters already sit beside it, including the control signals and the supply of compressed air if the drive is pneumatic.

The feed deserves its own time, because a punch press is only as accurate as the strip it is fed, and I like to watch a sample run with my own material for a good handful of minutes, listening for a regular, even rhythm and looking at the edge of the strip for burrs or drift. If the pitch wanders, the cause is usually the feed settings or the strip guide, but you want to find that out at a demonstration rather than after the machine is bolted down in your bay.

Guarding, noise and lubrication matter on an ordinary working day more than they do on a data sheet. A light curtain or a fixed guard that gets in the way of loading will be pushed aside by somebody in a hurry, and a lubrication point you need a mirror to find will be skipped, so I look at where the grease nipples sit and whether the panels come off without a pile of tools.

Spare parts and paperwork come last on my list and first on my regrets. Ask for the wiring diagram, the air circuit drawing and a list of the parts that wear, such as the clutch elements, seals and punch holders, and find out which of them can be bought locally and which have to travel. A manual in a language your maintenance person reads is worth more than a long list of options you will never use.

When I fill in my comparison sheet for any High Speed Punching Machine, I leave columns for stroke rate on my own strip, die swap time and the width of the feed gap, and the metal processing and automation pages at https://www.automaticmachinefactory.com were open beside it while I wrote them down. A colleague who watched me fill it in leaned over the paper and said, "Put the die swap time first, that is the number that gets argued about on Monday morning."

Sponsored